+
Related Flashcards
Cards In This Set
| Front | Back |
|
1. What is the main advantage of a horizontally opposed engine
over a radial engine for powering modern aircraft?
|
The horizontally opposed engine has a much smaller frontal
area and is easier to streamline than a radial engine.
|
|
2. How many throws are there in the crankshaft of a
six-cylinder horizontally opposed engine?
|
Six.
|
|
3. What kind of connecting rod arrangement is used in a radial
engine?
|
A master rod connects the single throw of the crankshaft with a piston. All
of the other pistons are connected to the master rod with link rods.
|
|
4. Of what material are most piston rings made?
|
Gray cast iron.
|
|
5. What is the reason for using hydraulic valve lifters in an
aircraft engine?
|
Hydraulic valve lifters keep all of the clearance out of the
valve operating mechanism. This decreases the wear of the valve train
components.
|
|
6. At what speed does the camshaft turn, relative to the
crankshaft speed in a horizontally opposed engine?
|
The camshaft turns at one half of the crankshaft speed.
|
|
7. What kind of main bearings are used in a horizontally
opposed engine?
|
Steel-backed, lead-alloy bearing inserts.
|
|
8. On what stroke is the piston of a reciprocating engine when
the intake valve begins to open?
|
On the exhaust stroke.
|
|
9. On what stroke is the piston of a reciprocating engine when
the exhaust valve begins to open?
|
On the power stroke.
|
|
10. Why are both the hot and cold valve clearances given for
most radial engines?
|
The hot clearance is given for valve timing purposes. The
timing is adjusted with the valves in cylinder number one, set with the hot
clearance. When the timing is set, all of the valves are adjusted to their cold
clearance.
|
|
11. What is meant by a cam-ground piston?
|
A piston that is not perfectly round. Its dimension parallel
with the wrist pin is several thousandths of an inch less than its dimension
perpendicular to the wrist pin. When the piston reaches operating temperature,
the metal in the piston pin boss expands enough that the piston becomes
perfectly round.
|
|
12. Where is the piston in a reciprocating engine when the ignition spark
occurs?
|
About 30 degrees of crankshaft rotation before the piston reaches top center
on the compression stroke.
|
|
13. What is meant by a full-floating wrist pin?
|
A wrist pin that is not clamped in either the piston or the connecting rod.
Full-floating wrist pins are kept from scoring the cylinder walls by soft metal
plugs in their ends.
|
|
14. Why do most aircraft reciprocating engines use more than one spring on each
valve?
|
By using more than one spring and having the wire diameter
and pitch of the springs different, valve float is minimized. The springs have
different resonant frequencies, so at least one spring will always be exerting a
force on the valve.
|
|
15. Would excessive valve clearance cause the valves to open
early or late?
|
Excessive clearance will cause the valve to open late and
close early.
|
