CDL Test Procedures Flashcards

Prepare for the CDL test procedures in a brief manner with these flashcards and revise the concepts related to it. Learn the important terms, definitions, and much more briefly with these flashcards quizzes. Be prepared for the CDL test procedures and master this topic with ease and fun by attempting Flashcards quizzes.

77 cards   |   Total Attempts: 188
  

Related Topics

Cards In This Set

Front Back
When preparing to do a pre-trip inspection you must check to see that the parking brakes are on and/or chocked.
A. True
Anytime you are going to get out of the truck, or near the truck in general, make sure the parking brake is on.
When getting in to start the engine and inspect inside the cab you must:
A. Make sure the parking brake is on.
B. Put gearshift in neutral (or park if automatic).
C. Start engine and listen for unusual noises.
Look at the guages - the oil pressure gauge should come up to normal within how long after starting the engine?
B. Seconds
If oil pressure doesn't come up within maybe 10 seconds, something is wrong. shut the engine down immediately.
You should check the following for looseness, sticking, damage or improper settings:
A. Steering wheel
B. Accelerator, brake and clutch pedals
C. Transmission controls
After inspecting mirrors and windshilds for cracks, dirt, illegal stickers, or other obstructions to your vision, you should:
Clean and adjust as necessary.
When checking lights you should:
A. Make sure that the parking brake is set.
B. Turn off the engine and take the key with you.
C. Turn on the headlights and four way flashers.
What should wheel bearing seals be checked for?
Hub oil level and no leaks
Hub oil either laying in the rim or covering the rim.
How many red reflective triangles should you carry?
3
How do you test hydraulic brakes for leaks?
Pump the brake pedal three times, apply firm pressure, hold for five seconds. The pedal should not move.
Why put the starter switch key in your pocket during the pre-trip inspection?
For your safety
To avoid roll backs when you start, you should:
Partly engage the clutch before you take your right foot off the brake
What is the proper way to hold the steering wheel?
Firmly with both hands on opposite sides of the wheel
Why should you back toward the driver's side?
A. Backing roward the right side is dangerous
B. So you can see better
When backing, why is it important to use a helper?
There are blind spots you can't see.
What is the most important hand signal that you and the helper should agree on?
Stop