CEM Training - HVAC Basics & System EFficiency Improvement

Optional

22 cards   |   Total Attempts: 188
  

Related Topics

Cards In This Set

Front Back
On average what is residental use of HVAC. Commercial use?
13% residental
20% commercial
as high as 30 to 50%
What are typical design ranges for temp & RH?

ventilation? what codes?
75F dry bulb
40-60% relative humidity

ASHRAE 62, 1999, 2001, 62.1-2004
20 CFM outside air per person (now 17 CFM)
or co2 less than 1000ppm
What are three types of temperature control strategies?
Constant volume - vary temp of supply air but keep rate constant
Variable air volume (VAV) - vary air flow rate while keeping supply temp constant
Variable Volume Reheat System - vary both temp & flow
What are ways of relative humidity control?

What's an issue with AC control related to this?
Humidification - if air too dry
Dehumidification - if air too wet
AC systems typically over-cool and then may have to reheat air, which requires additional energy
How much energy is req'd per pound of water?
1000 BTU
Four types of primary equipment
Chillers
Boilers
Furnaces
Direct Expansion Systems
What are the six secondary systems?
Single duct, single zone
Single duct, terminal reheat
Multizone system
dual duct system
Single duct, VAV system (most common)
Fan coil system
Do you want a positive or negative pressure on a single duct system and why?
Positive pressure b/c don't want rogue air able to get in.
What are two types of economizers?
Temperature or Dry Bulb economizers - doesn't account for humidity levels. (if it's 55F & 80%RH may not be good)

Enthalpy based economized will look at the overall btu content of the air
How does a single duct, single zone system operate?
Takes some air & mixes with outside air, goes thru economizer & then thru fan which operates at a static to overcome all downstream drops
How does a terminal reheat system different for SD, SZ?
At the end of ductwork, each zone has own coil & thermostat will control how much goes into coil.
Where does mixing occur in dual duct system?
Two ducts throughout, thermostat @ zone will determine level of mixing at the mixing box at the terminal.
What is the most common type of HVAC in large commerical buildings?
Single duct, VAV system - high efficient with use of VFD on supply air fan. Has local terminal box in the zone.
How much heating is the same as one ton of A/C?


one ton-hr?
12,000 BTU/hr


12,000 BTU
Where are fan coil systems typically used?

How do they operate?
Schools, hospitals, etc

Hot or cold air is sent thru the coil and the radiator works by convective heat transfer