CCNP Switch

CCNP Switch

11 cards   |   Total Attempts: 188
  

Cards In This Set

Front Back
Refer to the exhibit. The indicated configuration was established on the HSRP standby router RTB. However, the console message %IP-4-DUPADDR started appearing almost immediately on the RTB router. Given the output of the show standby brief command on RTA, what is the cause of the problem?
The group number 50 is missing in the Router RTB configuration commands.
Which statement correctly explains the process of mitigating ARP attacks on a switch where dynamic ARP inspection (DAI) has been configured?
The intercepted packets are verified against the DHCP snooping binding table for valid IP-to-MAC bindings
Refer to the exhibit. What feature does an SNMP manager need to be able to set a parameter on ACSw1?
A manager who is using host 192.168.0.5
Which statement is true concerning the core layer within the hierarchical design model?
Routing should be configured without traffic filtering, address translation, or other packet manipulation at the core.
When a port security violation occurs on a switch port, the switch sends a syslog message but does not shut down the port. What port security mode is in effect?
Restrict
Which three steps are required to configure interfaces as routed ports on a multilayer Catalyst switch? (Choose three.)
Enable IP routing globally.Assign IP addresses to routed ports.Disable Layer 2 functionality on interfaces that will be configured as routed ports.
A bridging loop occurs in a network and disrupts user connectivity. What action should be taken by a network administrator to restore connectivity?
Disable ports that should be in the blocking state.
Which three actions can cause problems with a VTP implementation? (Choose three.)
Question 9
Switch DLS1 is not the root bridge for VLAN 1.The Cost column in the lower part of the exhibit is not the cumulative root path cost.
Which QoS requirement should be taken into account when implementing VoIP in a campus environment?
The QoS requirements should accommodate the smooth demand on bandwidth, low latency, and delay for voice traffic.
When troubleshooting GLBP in an environment with a VLAN that spans multiple access layer switches, a network engineer discovers that suboptimal paths are being used for upstream traffic. What is the recommended solution?
Use HSRP instead of GLBP.