+
Cards In This Set
| Front | Back |
|
Specify the conditions of flight against which cargo must be restrained. 36.2
|
During take-off, in flight manoeuvres, air turbulence and landing.
|
|
Explain the effects of inadequate restraint on an aircraft load. 36.3
|
Unrestricted loads will continue to move in there origional speed & direction. Moving loads can jeapordize the safety of A/C and injure personnel
|
|
Explain the term restraint factor. 36.4
|
The restraint required to prevent items of load from moving.
|
|
Specify the restraint factors in terms of 'G' for fixed wing aircraft. 36.5
|
Forward 3G, Side 1.5G, Vertical (up) 2G, Vertical (down) 4G, Aft 1.5G
|
|
Specify the purpose of tie-down shackles. 36.7
|
They provide the means of attatching a tie down point to the A/C floor.
|
|
Tie-down shackles -
In what strengths is the HK Porter type tie-down shackles available? 36.6
|
2250 Kg, 4535 Kg & 11340 Kg
|
|
Which Tie-down shackle is only available in 4535 Kg strength? 36.6
|
The Aeroflex Type.
|
|
Tie down chains -
What are there strengths and lengths? 36.8
|
2 strengths - 2250 kg &4535kg
3 lengths - 7ft, 12ft & 15ft.
|
|
Where should tie-down chains not be looped?36.19
|
Around circular sections less than 3/8ths inches in diameter.
Around angular or flat sections with square or rounded edges less than 3/8ths inch thick
|
|
Tie-down chains -
when forming a loop around an attatchment point How must the 'grab' hook be located? 36.19
|
The concave face ofthe 'grab' hook must always face the standing part of the chain.
|
|
What are the colours of the 2250 & 4535kg tie-down chains? 36.8
|
7 foot - Orange/yellow
12 foot - Green
15 foot - Blue
|
|
How are the 'New' type of 4535 Kg QRC's identified? 36.9
|
They have 'Tongue in slot' jaws
|
|
Explain the restrictions applicable on the use of QRC's 36.11
|
Must be used with chainsof corresponding strength, Must be 'tongue in slot type & Must be only hand.
|
|
How can the jaws on the 'New' type QRC be confirmed as fully closed & locked? 36.10
|
The red dots on the operating ring and cover should be in alignment.
|
|
Ratchet strops are available in what lengths & strengths?
36.6E
|
One strength - 2250 Kg
Two lengths - 12' & 25'
|
