Front | Back |
During operation of the EPU-6/E frequency converter it is determined that E and F voltage is not needed for the aircraft. The operator places the Loop/Bypass/28V to Aircraft switch in what position?
|
Bypass
|
Which of the following components provides 525 VAC to the control transformer of the EPU-6/E frequency converter?
|
Input Auto Transformer
|
What EPU-6/E components receive potential directly from the input auto transformer?
|
SCR voltage regulator phase sequence transformer
|
The control transformer perform on the EPU-6/E frequency converter provides---
|
120 VAC for operation of E and F line 28 VDC power supply
|
What EPU-6/E frequency converter components must be inspected prior to use?
|
Air inlets for blockage
|
During operation you determine that there is an undervoltage fault problem with the EPU-6/E frequency converter unit. What component could be malfunctioning?
|
Analog board has failed
|
During operation of the EPU-6/E frequency converter you determine that one phase voltage is lower than the other two phases. What could cause this malfunction?
|
Loose push-on connector on the output filter capacitor
|
What AM32A-95 gas turbine compressor section supplies high volume, low pressure air for combustion, cooling and bleed air output?
|
Compressor section
|
The function of the deswirl ring on the A/M32A-95 gas turbine compressor it to---
|
Smooth turbulent air flow
|
What A/M32A-95 gas turbine compressor component isolates the second-stage air form the operation of the first-stage compressor?
|
Interstage seal
|
What prevents overpressurization of the bearing cavity on an A/M32A-95 gas turbine compressor?
|
Oil tank vent line
|
What A/M32A-95 gas turbine compressor chambers are pressurized when the butterfly valve is closed?
|
1, 3, and 4
|
The A/M32A-95 gas turbine compressor’s rate-metering valve prevents the butterfly valve from snapping open by bleeding air through the atmospheric bleed port form the chamber---
|
2
|
What A/M32A-95 gas turbine compressor closes to complete the electrical circuit to the fuel solenoid and ignition unit?
|
Oil pressure switch
|
The A/M32A-95 run up to 60 percent but the battery is not charging. What is the probable cause of this trouble?
|
K3 de-energized and the contacts did not remain closed
|